邓超的老婆叫什么名字
百度 近年来西南极和南极半岛的冰川物质加速消融，进一步加剧南极冰盖不稳定风险。
For questions about exhaust fans -- i.e. fans used to remove air from specific rooms in a building and exhaust it to the outside in order to control humidity and/or combustion products. Exhaust fans, unlike [ceiling-fan]s, are installed into the building's structure, either in a fitting within the room's ceiling, or remotely, drawing air from the room via a duct and grille.
533 questions
3
votes
1
answer
494
views
Changing bathroom fan switch - too many wires to fit?
I'm trying to replace an Intermatic dial timer bathroom fan switch with an Eaton model with a humidity sensor. The difference between the two is the old one had the connections through holes on the ...
- 39
0
votes
1
answer
38
views
What can I replace this vent hood motor with?
I'm replacing my vent hood motor because it's loud, but it's older and I can't identify it. The hood also looks like a custom job (the filters are a non-standard size -- 13x13 -- and the previous ...
- 3
0
votes
1
answer
48
views
Non-insulated exhaust fan duct goes out thru soffit, humid air condensing causing mold and drips out fan
2021 build, builder put 1st floor exhaust fan ducts out to soffits, uninsulated.
With the high humidity, the exhaust fan is just dripping condensation, which has caused my ceiling to mold/mildew. ...
0
votes
1
answer
73
views
Kitchen Microwave - Venting Externally [closed]
I want to vent my microwave range hood externally. I am on the first floor of a condo building and the stove location is not on an adjacent to outside wall, so clearly some challenges.
My microwave ...
0
votes
1
answer
59
views
Is my insulation good enought for bathroom vent duct in attic?
Installed new bathroom fan and rerouted the vent pipe from the roof to the soffit. My bathroom vent duct runs approx 6 ft through my attic to the installed soffit vent outside. The soffit vent design ...
- 1
0
votes
1
answer
123
views
How do I remove this bathroom fan?
How do I remove this bathroom fan motor? I cannot find any screws or anything.
- 43
3
votes
1
answer
320
views
Roof replacement and bathroom exhaust vents
I'm in Florida and having my roof replaced today so it might be good to properly vent my bathroom fans now, which currently just exhaust into the attic, so I rarely use them. I also have a ductless ...
- 123
3
votes
3
answers
521
views
Bathroom exhaust fan not working as expected
I have a bathroom exhaust fan in my bathroom. Over the years I noticed the ceiling has been peeling gradually (not sure what type of wallboard) as well as some condensation on the windows. The fan is ...
- 161
0
votes
1
answer
72
views
What are my options for installing and venting a bathroom exhaust fan?
Key things to consider:
-Ranch style single story home with basement built in 1969, located in Ohio.
-Hip roof (no gables).
-Existing chimney that was used to vent the furnace exhaust.
-Pretty sure ...
- 1
6
votes
1
answer
1k
views
How should I connect the wiring on my ReVent shower fan?
I am trying to install a ReVent RVL 50 shower fan and light. The old setup had a two light switches one fan the other light. But the wiring from the ceiling is one red wire, one white wire, one ...
- 63
1
vote
0
answers
65
views
Is this a good ground for an attic fan
I removed my old attic fan. Following the instructions I unscrewed the FMC from the old fan to be reused on the new fan. The FMC is then screwed on to the new fan and the other end of the FMC has a ...
- 4,348
0
votes
1
answer
180
views
Is there a bathroom fan that can both extract and ventilate air (2-in-1)? [closed]
I'm looking for a bathroom fan that can function both as an exhaust fan (to remove stale air and moisture) and as a ventilation fan (to bring in fresh air). Essentially, a reversible fan that can ...
- 103
0
votes
1
answer
100
views
What to do about poorly performing extractor fan
I have a Environvent 100 fan fitted in my ensuite. There is a about 0.5m of flexible ducting that connects onto a 90 degree bend and about 3m of straight ducting that then feeds out the house.
With ...
- 315
1
vote
1
answer
61
views
How to secure PVC vent duct for least noise?
TL:DR, will pvc duct be quieter if firmly secured or loosly secured?
I am installing a new vent duct for a kitchen extractor fan in a single storey house and plan to route rigid pvc duct through the ...
- 346
1
vote
1
answer
53
views
Can I use fiberglass batts to repair insulation in an attic with cellulose?
My house came with some Broan/NuTone 688K builder grade fans. In the interest of reducing the noise and increasing the flow rate, I've replaced them with some upgraded fans. The attic has blown-in ...
- 6,367